Finder User Guide | www.ff3dp.com
suffix is ”.fpp” in this type of file,all models in the scene (include support) are
independent .after reloading the files, extruder configuration information and model
position will be as same as the configuration during saving.
Click on [File]--[Save as...] to save the model as project file .fpp or .stl and .obj.
For .stl and .boj, models are integrated as one(include support part). If load it again,
only the position of the model was saved, not included the printing parameters.
Click [File]--[Preferences], you can choose language and if needs detecting update
● Language: The software supports six languages, that is Chinese(simplified Chinese
and traditional Chinese), English, French, Korean, Japanese and Russian.
● Printing Window Type: Including Base Mode and Expert Mode
● Check for Update after start up: It is used to set if needs to activate the online
automatic update function, if choose yes, every time when you open software, it can
online detect if there is new version software, once new version found, it will reminds
uses to download and install new version firmware.
To Next Page
Loading...
