Flashforge Finder - Page 62

Finder User Guide | www.ff3dp.com
62
6.2.1 Print from Computer (USB connection)
①用Connect your Finder with your PC via a USB cable.(Please refer to 5.1.13)
②Turn on your Finder, level the build plate and load the filament.
③ Click [Print] and transfer your Gcode file to your Finder. After completing
transference, the printer will heat up automatically. And when heating finishes, the
print will start to build the model.
④When your PC connects with FlashPrint successfully. The status box on the
bottom right displays the real-time nozzle temperature. After finishing preheating,
your Finder starts the print job directly.
6.2.2 Print from Computer (WIFI connection)
①用Connect your Finder with your PC via WIFI.(Please refer to 5.1.13)
②
Turn on your Finder, level the build plate and load the filament.
③ Click [Print] and transfer your Gcode file to your Finder. After completing