Level and
Calibration
Home Manual Internet Cloud
Camera About Status Maintenance Upgrade
Copy Log
How to replace the nozzle?
How to deal with clogged extruder?
How to remove flexible build plate?
What if the film on the flexible has
demaged?
>
>
>
>
>
>
>
>
>
>
< Maintenance
Users can click the [ ] - [Maintenance] to query the currently encountered problems.
As the firmware will be upgraded from time to time, please
refer to the actual display screens. The following is only a
brief introduction of functions.
ATTENTION
When operating the extruder, the power supply must be
disconnected.
ATTENTION
6. Maintenance
6.1 Maintenance Screen
The replacement method can be viewed by clicking the [How to replace the nozzle?]
on the maintenance screen. Please operate following the instructions on the screen.
6.2.1 Nozzle Replacement
6.2 Maintenance
< How to replace the nozzle
Screw
1. Please loosen the fixing screws as shown
in the figure and take down the nozzle
assembly.
2. Install the new nozzle assembly.
How to put flexible build plate?
How to change HEPA air filter?
How to clean filament clips in
the chamber?
How to deal with the noise of
XY axis moving?
How long you need to take care
of your screw and rails?
19
To Next Page
Loading...
