Scheme 1: Increasing the platform temperature can effectively alleviate this
problem, as the high temperature can increase the adhesion between
the platform and the model.
Scheme 2: Choosing to add a raft when slicing the model can effectively alleviate
this problem.
Scheme 3: Apply glue.
Scheme 4: If the distance between the nozzle and platform is too large, it should
be reduced accordingly, which can be done via the level and calibration
function.
Scheme 5: Confirm whether the platform is laid flat. The level and calibration
function can be used, and it is recommended to perform a full-process
automatic leveling.
Q9: The printed model is warping or not sticking well. How to deal
with this situation?
Not necessarily. When printing the raft, the filament extrusion amount is larger
and the printing success rate is higher. Under the condition of raft heating, the
adhesion between the model and the platform plate increases, which makes the
model adhere to the platform well when printing, and also increases the printing
success rate.
Q10: Must a raft be added when printing a model?
The format of the USB flash drive is incorrect. The equipment supports FAT32 file
system. Please format the USB flash drive into FAT32 format.
Q11: After inserting the USB flash drive, the print file can not be found,
and the screen displays all as folders. How to deal with this
situation?
1. Please check whether the Wi-Fi name contains special characters. If so, please
modify it and try again;
2. Please check whether the password contains special characters. If so, please
modify it and try again.
Q12: How to deal with Wi-Fi connection failure?
Please do not disconnect the power and the network when downloading or
updating the firmware to avoid update failure.
Q13: What are matters needing attention in updating the firmware?
If the start-up sound can be heard, please replace the screen or the flat cable;
If not, please contact our after-sales personnel.
Q14: Why is the boot screen white?
The battery needs to be purchased by yourself, with the model of LR44, 1.5V, and
the size of 11.6*5.1mm; compatible model: AG13/A76/L1154.
Q15: Is the battery used for the hygrometer in the filament chamber
configured in the machine? What is the battery model?
23
To Next Page
Loading...
