Flashforge Guider II - Chapter 4: Hardware Assembly; 4.1 Filament Installation

GuiderⅡ User Guide | www.flashforge.com
26
Chapter 4: Har dwar e Assembly
Your GuiderⅡ has been installed before leaving factory, you can start up the
GuiderⅡ for printing after mounting the filament spool and completing leveling.
4.1 Filament Installation
4-1
(4-1) The filament cartridge is at the rear of GuiderⅡ. Lift the cartridge out of the
Guider Ⅱ.
4-2
(4-2) Take out the filament and thread it through the filament detecting equipment.
(Note: The filament should feeds from the bottom of the spool towar ds the top )
Filament Detecting
Equipment in the black.