GuiderⅡ User Guide | www.flashforge.com
Chapter 5: Build Plate Leveling
GuiderII creatively adopts three-point intelligent leveling system, which will give
clear and comprehensive feedback to users. There are three spring-loaded knobs under
the build platform. The distance between the plate and nozzle increases while
tightening the knobs. On the contrary, the distance reduces.
(5-1) Tap [Tools] - [Level] on your GuiderII touch screen. Please wait while the
extruder and platform finish initial movements. After that, operate according to the
guide on the touch screen.
(5-2) After tapping [Yes], the extruder starts to move towards the first point and the
plate moves up and down to verify the distance between nozzle and plate.
To Next Page
Loading...
