Flashforge Guider II - 6.2 Exploring FlashPrint; 6.2.1 Machine Type Selection; 6.2.2 Software Introduction

GuiderⅡ User Guide | www.flashforge.com
34
6.2 Exploring FlashPrint
6. 2.1 Machine Type Selection
! After starting FlashPrint, you need to select the target machine type first.
When you start FlashPrint, a dialog box will pop up. Just select FlashForge Guider Ⅱ
in the machine type list and click [OK]. You can also change the machine type via
clicking [Pr int]--[Machine type]. See graphic 6-2:
6-2
6.2.2 Software Intr oduction
6-3