Flashforge Guider II - 4.4 Unloading Filament

GuiderⅡ User Guide | www.flashforge.com
29
(4-8) Tap [Filament]--[Load]
4-9
（4-9）After the extruder’s temperature reaches 220℃, the printer will sound a beep to
prompt you to load the filament into the extruder.
4-10
（4-10）Insert the filament into the extruder at an upright angle. Then the filament will
be drawn through the extruder. Do not tap [Cancel] until the filament load the
extruder steadily.
4.4 Unloading Filament
4-11