Flashforge Guider II - Page 46

GuiderⅡ User Guide | www.flashforge.com
45
⑤Raft: This function will help the model to stick well on the platform.
⑥ Wall: During dual color printing, this function will help to clear the leaking
filament of another extruder.
⑦Brim: Expand the outline of model’s bottom layers to a Brim which helps anchor
the edges of the model to the plate to avoid warping.
⑧ Resolution ： You have three resolution solutions (with default setting)to choose
from, high resolution is corresponding with slow printing speed, opposite for the low
resolution. For PLA printing, an extra solution “Hyper” is available.
⑨ Mor e options: Click [Mor e options] to set for layer, shell, infill, speed and
temperature. Different resolution solution is corresponding to different defaults, click
[Restor e Defaults] to back to default setting.
●Layer
a. Layer : Layer thickness of the printing model. With a small value, the surface
of the model will be smoother.
b. Fir st Layer Height: This is the first layer of the model, which will affect the
sticking performance between the model and platform. Maximum is 0.4mm, usually
the default is OK.
c. Shell: Contains the outside shell value, capping layer value (under vase pattern,
top solid layer setting is invalid.)
● Per imeter Shells: Maximum is 10
a. Top Solid Layer : Maximum is 30, minimum is 1.
b. Bottom Solid Layer : Maximum is 30, minimum is 1.
● Infill
a. Fill Density means fill rate.
b. Fill Patter n is the pattern of filling shape which effects printing duration.