GuiderⅡ User Guide | www.flashforge.com
Click [File]--[New Pr oject] can build a blank project. If there is an unsaved
modification on previous project, then it will inform you whether the modification
needs to be saved or not. Click [Yes] will save the modification, while click [No] will
abandon it. If click [Cancel] or close tool tip, then will cancel the new project.
After finishing the model edit and adjustment, there are two ways below to save all
Click [File]--[Save Pr oject] in the menu bar to save the file as a project file with the
“.fpp” suffix, all models in the scene (include support) are independent. After
reloading the files, extruder configuration information and model position will be the
same as the configuration during saving.
Click on [File]--[Save as...] to save the model as project file .fpp or .stl and .obj.
For .stl and .boj, models are integrated as one(include support part). If load it again,
only the position of the model was saved, not included the printing parameters.
Click [File]--[Pr eferences], you can choose language and if needs detecting update
To Next Page
Loading...
