Flashforge Guider II - Page 58

GuiderⅡ User Guide | www.flashforge.com
57
on the build area. Click [Back] and double-click the Move icon again, then click [On
the Platfor m] and [Center] to ensure the model be on the platform.
7-4
Note：If you’ve place your model in a r ight place, you can skip the step above.
(7-5) Click the [Pr int] icon on the top, you should make some setups for your print
job.
Pr eview: If you check the [Pr eview] box, you can preview your model after slicing is
7-5