Flashforge Guider II - Chapter 9: Basic Questions and Answers; 9.1 Extruder shakes from left and right when printing.; 9.2 1025 extruder temperature showed on printers touch screen when heating or printing.; 9.3 Extruder temperature does not go up when preheating or loading filament.

GuiderⅡ User Guide | www.flashforge.com
71
Chapter 9:Basic Questions and Answer s
Note! Do not disassemble the pr inter for maintenance on your own without
author ization, or it may cause unnecessar y loss! Please contact Flashfor ge
after -sale engineer s and use cor rect instruction and method to maintain.
9.1 Extr uder shakes fr om left and r ight when pr inting.
Step 1. X-Axis motor cable has loose contact: Reconnect the X-Axis motor cable to
check, if problem remains, replace with new X-Axis motor cable.
Step 2. If Step1 not solving, X-Axis driver board has problem: Replace with new
X-Axis driver board.
9.2 “1025” extr uder temper atur e showed on printer’s touch
scr een when heating or printing.
Step 1. Extruder thermocouple has loose contact or has problem: Reconnect the
extruder thermocouple to check, if problem remains, replace with new extruder
thermocouple.
9.3 Extr uder temper atur e does not go up when preheating or
loading filament.
Step 1. Heating pipe joint is disconnected with heating pipe: Reconnect these two parts
back.
Step 2. If Step1 not solving, heating pipe joint is disconnected from the exchange
board: Weld the heating pipe joint back if you are experienced in welding, or please
replace with new exchange board.
9.4 Extr uder is moving to the r ight side without stop when
pr inting.
Step 1. X-Axis sensor wire has loose contact or has problem: Reconnect the X-Axis