Note: during typesetting, the distance between each
model shall be more than 0.5mm. If stacking prints is
required, the distance between the upper and lower
models shall not be less than 0.5-1 mm. Please make
sure that the models are at the same level to avoid a
waste of time and material.
add icon.
printing task list icon in the bottom of printer interface. Tap
01 02 03 04 05 06 07 08
09 10 11 12 13 14 15 16 17
18 19 20 21 22 23 24 25 26
27 28 29 30
31 32 33 34 35
36 37 38 39 40 41 42 43
44 45 46 47 48 49 50 51
52 53 54
55 56 57 58 59 60 61
62 63 64 65 66 67 68 69
70 71 72 73 74 75 76 77
78 79 80 81 82 83 84 85
86 87 88 89 90 91 92 93
94 95 96 97 98 99 100 101
102 103
To Next Page
Loading...
