6600 – 6665 – 6700 – 6765
E
N
G
L
I
S
H
25
8 - ADVANCED PROGRAMMING MODE
6700 / 6765
The valve is in service position. To enter in the advanced programming
mode, push and hold the button for 5 seconds.
Then depress the button
for 5 seconds.
You are in the advanced programming mode.
8.1. Flow rate (Fr) in l/min
Not viewed in timeclock regeneration mode
Ex.: 8,6 l/min not adjustable [Fr - - 8.6]
8.2. Days since the last regeneration (d)
Not viewed in timeclock regeneration mode
Ex.: 2 days not adjustable [d - - - - 2]
8.3. Prior service volume used in litre
(1)
Ex.: 3483 l not adjustable [E - -3483]
8.4. Reserve capacity (rc) in litre
(1)
Ex.: 852 l not adjustable [rc - - 852]
8.5. Previous days water usage (Pd) in litre
(1)
Ex.: 284 l not adjustable [Pd - -284]
8.6. Chlorine cell activation (J)
Ex.: - Chlorinating activated during the cycle 1 [J - - 1]
- No chloration [J - - OFF]
8.7. Chlorine cell power on duration
Ex.: 20 mn [Jd- - - 20]
8.8. Regeneration day override (A)
Ex.: - Override every 7 days [A - - - - 7]
- Cancelled setting [A - -OFF]
Note: in timeclock regeneration, never
cancel this setting.
8.9. Volume override (b) in litre
(1)
Ex.: Regenerate every 5000 litres [b- - 5000]
Note: if b is set, water hardness and system capacity are not viewed.
Note :
1. Push the button once
per display.
2. Option settings may be
changed by pushing the
and set buttons
(1) The unit of measure depends on the display format chosen.
All examples above are based on the cubic meter format (see point 6.17).
To Next Page
Loading...
Need help?
General
