FT-112(D) Panel Weighing Indicator, Technical Manual, Rev.1.0.0, May 2019 Page 36 of 170
Specified tare (PT) memory
If you have specified containers, which are used frequently and if you prefer to enter their weight manually
instead of taring every time, you may record their weights into the Preset tare memory. Up to 500 specific tare
values can be recorded.
Recording the specific container weight into the preset tare memory
1. Press key for more than 2 seconds at basic weighing. The [ MEMORY ] message will
appear on the display.
2. Press key to enter memory. The last entered specific tare code appears as [ PT : 111 ].
3. Press numerical keys to enter the specific tare code. Or press or keys to navigate in
the memory. Press key to access PT memory code shown on the display.
4. The previous specific tare value appears on the display. Enter the new value by pressing numeric
keys. Press key to save or press key to escape.
5. After saving the entry the next memory code will appear. Follow from item 3 to entry PT values
into other codes.
6. Press key to return to the operation.
Recording the indicated weight into the preset tare memory
1. Empty the scale and press key until symbol appears on the display.
2. Place the container on the scale.
3. Press key for more than 2 seconds at basic weighing. The [ MEMORY ] message will
appear on the display.
4. Press key to enter memory. The last entered specific tare code appears as [ PT : 111 ].
5. Press numerical keys to enter the preset tare memory code. Or press or keys to
navigate in the memory. Press key to access PT memory code shown on the display.
6. The previous specific tare value appears on the display. Press key to save indicated
weight to the PT memory.
7. Press key to confirm.
8. Press key to return operation.
Taring from the preset tare memory
1. Press key and key in sequence at basic weighing to enter PT memory.
2. The last entered preset tare memory code appears.
3. Press numerical keys to enter the preset tare memory code. Or press or keys to
navigate in the memory.
4. Press key for specific taring. Or press key to return operation.
Net sign correction
Some weighing of materials is done by unloading the material from the container. The net sign correction
enables always positive net weighing at loading and at unloading the material from scale by switching gross
and tare weights, if necessary. Refer to parameter 237 to enable net sign correction.
Enabled net sign correction affects the display and printed data.
To Next Page
Loading...