FT-112(D) Panel Weighing Indicator, Technical Manual, Rev.1.0.0, May 2019 Page 15 of 170
Passwords
RELATED PARAMETERS: Sub-block 26- .
3.4.1 Keylock
FT-112(D) Panel has the capability to lock the keys to avoid unauthorized interfere. The key(s) which would be
locked are programmed in the setup at sub-block 34- . Key lock password default is 11.
Lock the keys:
1. Press key for more than 2 seconds. [LOCK PASSWORD: ] prompt appears on the display.
2. Enter the key lock password. Refer to parameter 261.
3. Press key. symbol appears on the display.
Unlock the keys:
1. Press key for more than 2 seconds. [LOCK PASSWORD: ] prompt appears on the display.
2. Enter the key lock password.
3. Press key. symbol disappears on the display.
3.4.2 Passwords
RELATED PARAMETERS: Sub-block 26- .
Keylock password
This password can be used to lock the keys and to erase the grand total by authorized person.
The default password is 11. Refer to sub-block 34- and the parameter 325.
User password
This password is used to setup the interface, usage configuration and application related parameters for
your application. The default password is 1111.
Service password
This password is used by trained technical persons to access parameters of the instrument and
calibration only. The default password is 1111.
To Next Page
Loading...