FLIR Ariel CM-3102 - Page 12

Document Scope and Purpose
4
Ariel CM-3102 User and Installation Guide
December 12, 2018
Warning:
 Do not drop the camera or subject it to physical shock.
 Do not touch sensor modules with fingers. If cleaning is necessary, use a clean cloth with a
bit of ethanol and wipe it gently. If the camera will not be used for an extended period of time,
put on the lens cap to protect the sensor from dirt.
 Do not aim the camera lens at strong light, such as the sun or an incandescent lamp, which
can seriously damage the camera.
 Make sure that the surface of the sensor is not exposed to a laser beam, which could burn
out the sensor.
 If the camera will be fixed to a ceiling, verify that the ceiling can support more than 50
newtons (50-N) of gravity, or over three times the camera’s weight.
 The camera should be packed in its original packing if it is reshipped.
Caution:
To avoid damage from overheating or unit failure, assure that there is sufficient temperature
regulation to support the unit’s requirements (cooling/heating). Operating temperature should be kept
in the range -40° to 50°C (-40° to 122°F) for CM-3102-x-I models and -20°C to 65°C (-4° to 149°F)
for CM-3102-xE-I models, with no more than 90% non-condensing humidity.
Attention:
Afin d'éviter tout dommage dû à une surchauffe ou toute panne de l'unité, assurez-vous que la
régulation de température est suffisante pour répondre aux exigences de l'unité
(refroidissement/chauffage). La température de fonctionnement doit être maintenue dans la plage (-
40° à 50°C/-40° à 122°F) pour les modèles CM-3102-x-I et de (-20°C à 65°C/-4° à 149°F) pour les
modèles CM-3102-xE-I, sans condensation d'humidité supérieur à 90%.