FLIR Ariel CM-3102 - Figure 42: Basic Operations Screen

Accessing the CM-3102 via a Web Browser
42
Ariel CM-3102 User and Installation Guide
December 12, 2018
 Restoring partial factory defaults
 Restoring full factory defaults
Figure 42: Basic Operations Screen
Click Reboot to save configured settings.
Click Partial factory defaults to restore factory defaults, but retain network settings (IP address,
netmask address, and gateway address), TV format, and image rotation settings.
Click Full factory defaults to restore factory defaults, including network settings.
Caution:
Selecting Full factory defaults causes the camera to lose all network settings.
Attention:
Sélection par Défaut Complet d'Usine entraîne la caméra de perdre tous les paramètres réseau.
To select the TV format
Select Basic Configuration > Basic Operations. The Basic Operations screen is displayed.
From the drop-down list, select NTSC or PAL. The default is NTSC.
To import a setting
Click Browse to select the file.
Click Import to upload the file.
To export a setting
Click Export. An information bar opens.
Click Save in the information bar to save the file.
To reboot the camera
Click Reboot. The camera reboots. After the reboot finishes, a popup window opens with the
message “Rebooting complete”.
Click OK. A dialog box opens, requesting you to close the tab in your browser.
Close the tab.
Open a new tab in your browser, and re-enter the camera’s IP address. The camera’s Login
window opens.
Enter your login credentials. The camera’s home page opens.