Accessing the CM-3102 via a Web Browser
Ariel CM-3102 User and Installation Guide
To restore partial factory defaults
Click Partial factory defaults. The camera reboots. After the reboot finishes, a popup window
opens with the message “Rebooting complete”.
Note:
Since the unit’s IP address might change when restoring full factory defaults, it is
recommended to use DNA to discover the unit after rebooting.
Click OK. A dialog box opens, requesting you to close the tab in your browser.
Close the tab.
Open a new tab in your browser, and re-enter the camera’s IP address. The camera’s Login
window opens.
Enter your login credentials. The camera’s home page opens.
To restore full factory defaults
Click Full factory defaults. The camera reboots. After the reboot finishes, a popup window
opens with the message “Rebooting complete”.
Note:
Since the unit’s IP address might change when restoring full factory defaults, it is
recommended to use DNA to discover the unit after rebooting.
Click OK. A dialog box opens, requesting you to close the tab in your browser.
Close the tab.
Open a new tab in your browser, and re-enter the camera’s IP address. The camera’s Login
window opens.
Enter your login credentials. The camera’s home page opens.
To Next Page
Loading...
