To change the date and time
Select one of the following options
Manual Settings – Enter the date and time in the respective field.
Synchronize with PC – Enter the date and time in the respective field.
Synchronize with NTP Server – Selecting this option opens the NTP Settings section:
Figure 38: NTP Setting Section
Enter the following details in the NTP Setting section:
Enable – From the drop-down list, select Manual to set the NTP server manually,
or From DHCP Server to set the time according to the network DHCP server.
Server Address – Enter the IP address for the NTP server.
Synchronization Period – Select a number between 1-24 for the frequency (in
number of hours) that the camera will synchronize with the NTP time server (i.e.,
every one hour, every two hours, etc.).
In the Time Zone Setting section, from the Area drop-down list, select your local time zone.
Click Save. The new time is displayed in the Current Camera Time text box.
6.3.1.2.2 Audio (CM-3102-11-I only)
Available only on the CM-3102-11-I, the Audio screen is used for configuring Audio In settings.
Figure 39: Basic Configuration > Audio Screen
To enable audio settings
From the Enable drop-down list, select ON.
From the Encoding drop-down list, select G.711 a-law, G.711 μ-law, or AAC. The default is AAC.
From the Level drop-down list, select High, Mid, or Low.
To Next Page
Loading...
