6.3.1.6.4 SD Card
The SD Card screen is used for configuring the microSD card. The card status is displayed in the Mount
Status row. The status is displayed as mounted if the microSD card is installed and not_mounted if the
card is not installed.
Figure 83: Events Handler > SD Card Screen
To configure the microSD card
From the Overwrite drop-down list, select ON. The default is OFF.
Click Save.
6.3.1.6.5 Snapshot
The Snapshot screen is used for configuring snapshot settings.
Figure 84: Events Handler > Snapshot Screen
To configure snapshot settings
In the Pre-Event Capture Count text box, enter the number of frames (1 to 10) to capture before
taking a snapshot of an event. The default is 3 frames.
In the Event Capture Interval text box, enter the time interval (1 to 10 seconds) to capture
between snapshots. The default is 1 frame.
In the Post-Event Capture Count text box, enter the number of frames (more than one) to
capture after taking a snapshot. The default is 3 frames.
Click Save.
To Next Page
Loading...
