In the IR Control section, configure the following settings:
Mode – Select Auto, ON, or OFF. The default setting is Auto.
LED Brightness – Select High, Medium, or Low. When set to High, the camera switches with
almost no delay between Color and B/W modes. The default setting is High.
Click Reset if you want to return to factory default settings.
6.3.3.1.2 Advanced Mode
Advanced mode sets the camera’s shutter speed to automatically achieve a consistent video output
level. This mode is recommended for outdoor environments and indoor environments with fluorescent
lighting as the main light source.
Figure 92: Advanced Exposure Mode Settings
Continue to configure the other settings in the Exposure section:
Max Shutter Speed – Select a suitable shutter speed according to the environmental luminance.
The following table displays the options:
To Next Page
Loading...
