In the Day/Night Switch Control section, configure the following settings:
Mode – The Day/Night switch activates the IR Cut (IRC) filter for electronic day/night operation.
Three modes are available: Auto, Color, and B/W.
Auto – Select Auto for automatic operation according to the ambient light level. The
camera converts from Day (color) mode to Night mode (monochrome/black and white)
automatically at nighttime or in low-light conditions. When there is sufficient light, the
camera converts automatically from Night mode to Day mode. This is the default setting.
Color – Select Color for daylight operation. This deactivates IR mode by putting the
camera into Day mode.
B/W – Select B/W (black and white) for nighttime operation. This activates IR mode by
putting the camera into Night mode.
Time – Select Fast, Normal, or Slow to set the reaction time of the IRC filter. When set to Fast,
the filter switches faster between Day and Night modes. The default setting is Normal.
Sensitivity – Use the slider to set the sensitivity between Low and High when switching from Day
to Night mode or Night to Day mode. When set to High, the camera automatically switches
between Day and Night modes upon minor changes in light intensity. When set to Low, the
camera automatically switches between Day and Night modes upon major changes in light
intensity.
In the IR Control section, configure the following settings:
Mode – Select Auto, ON, or OFF. The default setting is Auto.
LED Brightness– Select High, Medium, or Low. When set to High, the camera switches with
almost no delay between Color and B/W modes. The default setting is High.
Click Reset if you want to return to factory default settings.
To Next Page
Loading...
