Programming the camera
21
21.1 General
You can program the camera to save images periodically.
21.2 Procedure
Follow this procedure:
1. Push the Menu/Back button or tap the screen to display the menu system.
2. Use the joystick to go to
(Mode). This will display the Mode submenu.
3. One the Mode submenu, select Program and push the joystick. This will display the
Program dialog box.
4. Select Duration between images and push the joystick. This will display a dialog box
where you can set the time interval between each saved image.
5. Set the stop condition. You can choose between three different stop conditions:
• Manually: Select this option to manually stop the periodic saving by pushing the
Preview/Save button.
• Number of images: Select this option to stop the periodic saving after a set num-
ber of images has been saved. When you select this option a dialog box appears.
• Total time duration: Select this option to stop the periodic saving after a defined
period of time. When you select this option a dialog box appears.
6. When you are finished, push the Menu/Back button.
7. Start the periodic saving by pushing the Autofocus/Save button.
#T559598; r. AB/ 9443/9443; en-US
59
To Next Page
Loading...
