Shutting Down the Machine
56
04/03/2020 218333
7.2 Press Emergency Stop of the Machine
The control panel emergency stop button is used by the operator as a safety
switch while working on and with the machine.
You can use the emergency stop button to immediately stop all drives and
movements of the machine in the event of imminent danger, regardless of the
currently selected operating mode or function.
In the event of an interruption by emergency stop, the machine and the
movements triggered by the actuation push-buttons are stopped immediately,
i.e. they do not continue to move:
Press the emergency stop button to immediately stop the machine.
The control system and the control panel of the machine remain
switched on
The drive motor and drill light are switched off.
Attention
You have shut down the machine for safety reasons. Before you switch the
machine on again, you must eliminate (have eliminated) the cause of this in-
terruption. Specialized work on the mechanics and electrics may only be car-
ried out by technical staff.
Note
However, you should normally not use the emergency stop button to shut
down the machine (normal shutdown), since this immediately stops the con-
trolled movement of the machine.
Always press the emergency stop button only in case of danger or to reset the
control system.
The emergency stop button is self-locking. This means that you cannot oper-
ate the machine until you have eliminated the cause for the interruption and
unlocked the actuated emergency stop button.
To Next Page
Loading...
