Flott SB 18 Plus - Reinstalling the Protective Hood Securely

Maintenance of the Machine
68 04/03/2020 218333
9.3.2 Installing the Protective Hood
1. Put the protective hood slightly tilted forward on the ma-
chine head.
2. Feed the connection cables for the control panels through
the individual openings of the protective hood.
3. Lower the protective hood onto the machine head and
make sure that it fits correctly.
4. Insert the 2 side Phillips screws into the protective hood
and tighten them by hand.
5. Use an SW13 hexagon wrench to screw in the drilling
depth limiter on the right side of the protective hood.