Flott SB 18 Plus - Dismantling the Drill Chuck Safely

Maintenance of the Machine
218333 04/03/2020 63
9.2 Dismantling Drill Chuck
Danger
Danger due to unintentional start-up of the machine.
You must shut down the machine prior to starting any maintenance or cleaning
work.
Attention
Damage to the spindle or drill chuck.
Make sure that when dismantling the chuck, it does not fall onto the drilling ta-
ble or vise. This can cause damage to components and render them unsuita-
ble for further use.
1. Switch off the machine (see section 7.1 Switching the machine off, page
55).
2. Swivel the drill guide to the left side.
Attention
Danger due to hot cutter.
The cutter may still be hot after use. Cool the cutter with coolant or remove it
with a protective glove.
3. First, remove the cutter from the chuck before disassembling the chuck.
4. Turn the drill lever down until the lateral pin openings are
visible.
Hold the drill lever in this position.
5. Hold the drill chuck tight with one hand so that it does not
fall onto the drilling table or vise after dismantling and is
damaged.
6. Insert the pin punch through the side opening of the quill.
Make sure the rounded side is at the top.
Attention
Damage to the quill.
Pay attention to the correct insertion of the pin punch in the quill. Never move
the quill with the drill level turned up when the pin punch is inserted to loosen
the chuck. This will damage the quill, and may render the machine unsuitable
for further use.