Before Using the Machine
218333 04/03/2020
37
5.4 Checks Before Commissioning
Before putting the machine into operation, you need to check some points.
These checks are needed for the safety and work preparation of all persons
working on the machine.
Take the utmost care in these checks so that you do not unnecessarily endan-
ger yourself, other persons or the machine.
Workplace
Make sure your workplace
Is always clean and dry, especially in places where entry of liquid metal
or cinder is possible
If it is located in areas where flames and splashing out fire-liquid mass is
expected, it has inlets and outlets that allow a fast and safe leaving of
the risk area
Has enough space in the area around the machine and
Has sufficient lighting adapted to the workplace.
Personal protective equipment
Since you as the operator carry out various activities, you should always have
a minimum of protective equipment.
Wear during all activities on and with the machine:
Safety goggles
If necessary, hearing protection
Safety shoes and
Work clothing
Safety equipment
Make sure, that
Nobody is inside the safety area ofthe machine
Only authorized personnel are at the machine
All safety devices are present and functional
(see section 2.3 Safety devices of the machine, page 25).
To Next Page
Loading...
