Operating the Machine
218333 04/03/2020
49
6.5 Tapping with Depth Adjustment
Tapping is carried out with a tap suitable for the pre-drilled hole. As soon as
the pre-set threading depth is reached, the direction of rotation of the spindle
automatically reverses so that the tap is move out of the cut thread.
Use safety goggles
Always wear the necessary goggles when working on and with the machine!
Warning
Danger due to fast rotation of the drill spindle.
Fast rotation of the drill spindle can result in hair or clothing being pulled in.
This can lead to serious injuries.
Therefore, during operation of the machine
It is mandatory to wear a hairnet for long hair or a suitable headgear
Never wear gloves, neckties, bracelets, finger rings, chains or other loose
clothing.
1. Carry out all necessary work to prepare the machine (see section 5 Before
using the machine, page 30).
Then the tap is clamped and the machine set to the required height.
2. Clamp the workpiece in the mounted vise.
Attention
Danger due to repeated loads.
The repeated lifting of heavy weights can lead to unfavourable body loads and
rapid fatigue. When handling workpiece weights > 10 kg, use a suitable hoist
for loading and unloading operations.
3. Unlock the emergency stop button. Only for 20,23,25 Plus
Then the control system is restarted and the display appears:
After starting the control system, the drilling type Drilling shall always be
preselected.
To Next Page
Loading...
