Operating the Machine
48
04/03/2020 218333
11. Use the three-arm-lever to slowly move the drill bit towards the workpiece
by pressing down on the three-arm-lever.
Drill the through hole or blind hole in the workpiece.
As soon as the pre-set drilling depth is reached, a signal ("beep") sounds.
In addition, the drilling depth is shown in the display.
12. Then return the three-arm-lever back to its initial position.
13. Press the push-button to stop the machine.
The lamp lights up when the drive is off.
The machining operation is over.
To Next Page
Loading...
