Shutting Down the Machine
218333 04/03/2020
55
7 Shutting Down the Machine
7.1 Switching the Machine Off
Warning
Danger due to faulty electrical connection.
Observe the electrical connection values in the operating manual and the rat-
ing plate when connecting the machine.
Excessive connection voltage may cause operator injury and damage to
the machine.
If the connection voltage is too low, the machine motor may be damaged.
The earthing contact plug has an earthing conductor and may only be re-
placed with an original component.
The system is switched off exclusively at the control panel of the machine.
1. Press the push-button to switch off the machine.
The spindle rotation is stopped and the display remains on.
2. Only for SB/TB/TBZ 20,23,25 Plus:
Turn the main On/Off switch to the 0 position to turn off the machine com-
pletely.
All control lamps, the drill light and the display are switched off.
3. Disconnect the earthing contact plug from the mains supply.
All control lamps, the drill light and the display are switched off.
4. Inspect the machine for contamination that may have been caused by the
work process. Please observe the information in section 9 Maintenance of
the machine, page 61.
5. Make sure that the protective hood is firmly attached to the machine. Under
the protective hood there are components that carry residual voltage for a
short time after disconnection from the mains supply. They need at least 15
min. to discharge independently.
Now you have shut down the machine correctly.
To Next Page
Loading...
