ATTENTION!
Incorrect storage or transport
can damage the unit.
➢ Close all openings with the
covers supplied or similar
covers.
➢ Make sure the unit is dry
and protected from corrosive
atmospheres where it is
stored.
➢ Contact the manufacturer
for advice if you need to
store or transport the unit
under other conditions.
Storing the Actuator
Store the unit only under the follow-
ing conditions:
Do not store it for more than 24
months.
Close all connection openings with
the covers supplied or similar covers.
The connection surfaces and sealing
surfaces must be protected against
mechanical damage.
The unit and all its components must
be protected from blows and shocks.
Secure the unit to prevent it falling
or tipping.
The unit shall only be installed in-
doors under the following environ-
mental conditions:
Relative humidity below 50 %,
non-condensing
The room air must be clean and
not contain salt or other corrosive
substance
Temperature 5–40 °C.
When storing, make sure these con-
ditions apply at all times.
Contact the manufacturer for advice
if you need to store the unit for long-
er or under other conditions.
To Next Page
Loading...
Need help?
General
