Flowserve ARGUS E25 MOD II User Manual

Argus E25 MOD II - Operating Instructions
38
Removing the unit
DANGER
When working on equipment
and components carrying elec-
tric voltage, or on pipework, very
serious injuries or death can be
caused by electric shock, burns,
high pressure in the system, or
poisoning.
➢ Make sure there are no hot
or hazardous media on the
unit or the pipelines.
➢ If the valve is installed, make
sure there is no residual
pressure in the pipeline.
➢ Make sure the unit is dis-
connected from all electric
power supplies.
➢ Make sure the plant is
switched off and secured
against unauthorised
switching back on.
➢ Make sure the unit and
pipelines have cooled so
that they are no more than
hand warm.
➢ Wear suitable protective
clothing and, when neces-
sary use suitable protective
equipment.
For more information about suitable
protective clothing and protective
equipment, see the safety data sheet
for the medium being handled.
CAUTION
Danger of crushing injury if the
unit falls or tips.
➢ When dismounting the unit
employ suitable measures to
secure it against falling.
Suitable measures are, for example:
Having a second person to support
the unit.
In locations with restricted access,
support heavy units with lifting gear
with adequate load capacity.
Undo the unit’s connections to the
valve.
Lay the unit on a suitable surface.
WARNING
Danger of injury from reaching
into the unit.
➢ Secure the unit during test
runs.
If necessary, dismantle the unit from
the valve on which it is installed.
Ensure that the valve and pipeline
are pressure-free.
When doing this, observe and follow
the instructions supplied for the
valve.
Remove the valve together with the
actuator from the pipeline.
Store the combination of actuator
and valve on a suitable support.
Store the unit as described in the
section “Storing the Actuator” .

Flowserve ARGUS E25 MOD II Specifications

General

Brand	Flowserve
Model	ARGUS E25 MOD II
Category	Controller
Language	English