Technical data
You will find all relevant technical data
for the ARGUS E25 MOD II on the unit’s
type plate, and in the Technical Data
Sheet.
Working clearance
To be able to remove the unit from an
installed valve, you need at least 750
mm working clearance above the unit.
Application limits
Details of the application limits are
given on the unit’s type plate.
CE Conformity / Certifica-
tion
On the following pages you will find a
copy of the EU Declaration of Con-
formity for the ARGUS E25 MOD II.
If the declaration has since been up-
dated or modified, it will be supplied
with the unit or can be downloaded
from our website.
The declaration certifies under the
responsibility of the manufacturer that
on the grounds of the design, manufac-
ture and quality assurance of the elec-
tric actuator:
The essential requirements for a
"partly completed machine" within
the meaning of Directive 2006/42/EC
(Machinery Directive) are fulfilled
and
the explosion protection in accord-
ance with Directive 2014/34/EU
("ATEX Directive") in the designated
classification is guaranteed.
In compliance with the respective regu-
lations concerning their applicability,
Directive 2014/35/EU (“Low Voltage
Directive”) and 2014/30/EU (“EMC
Directive”) are not mentioned in the EU
Declaration of Conformity.
The appendix also includes the EU
Type Approval Examination Certificate
(ATEX).
Certificate No. IECEx EPS 15.0046x,
issued by Bureau Veritas, certifies the
classification and conformity with the
requirements for explosion protection
according to IECEx.
Since 1988, the quality assurance sys-
tem for our works manufacturing ball
valves and actuators in Ettlingen, Ba-
den, has been certified as meeting the
requirements of the international
standard ISO 9001.
To Next Page
Loading...
Need help?
General
