LTQ008 – LTQ230 Series 3-Phase Products User Instructions – AIIOM000165 EN
Page 39 of 40
Annex A: Glossary
Below are terms and definitions used throughout this manual:
1. BAS is an industry acronym for a building automation system.
2. BIC is an industry acronym for Basic Integral Controls.
3. CCW denotes the Counterclockwise direction for movement.
4. CW denotes the Clockwise direction for movement.
5. F.C. denotes the operational status of the actuator when fully closed.
6. F.O. denotes the operational status of the actuator when fully opened.
7. FS denotes a product manufactured with Fail Safe built-in.
8. LCS is an industry acronym for a Local Control Station.
9. MCC is an industry acronym for a Motor Control Center.
10. NCU is an industry acronym for No Controls Units.
11. PC denotes a product manufactured with Phase Correction circuity built-in.
12. PCB is an industry acronym for printed circuit board.
13. PLC is an industry acronym for a programmable logic controller.
14. PP denotes a product manufactured with Phase Protection circuitry built-in.
15. REV denotes a product manufactured with Reversing Motor Starters built-in.
16. TS denotes a product manufactured with Torque Switches.
17. VAC is an industry acronym for volts alternating current.
18. VDC is an industry acronym for volts direct current.
19. XFS denotes a product manufactured without Fail Safe built-in.
20. XLCS denotes a product manufactured without a Local Control Station.
21. XPP denotes a product manufactured without Phase Protection circuitry built-in.
22. XREV denotes a product manufactured without Reversing Motor Starters built-in.
23. XTS denotes a product manufactured without Torque Switches.
To Next Page
Loading...
