7 - 6 92B/96B/99B/105B Users Manual
To see the current as a waveform, set the test tool as
follows:
Set Current Probe range switch to 10 mV/A.
+
Do a Reset; probe scaling factor is 10:1.
Select Scope mode.
Select Continuous Auto Set.
Select the Probe A menu.
Open the Probe on INPUT A box.
:10 mV/A
Select current range.
Close the window.
The test tool displays the current as a waveform,
which can be analyzed using all other functions. The
selected range appears on the top display.
Figure 7-5. Current Measurement in Scope Mode
To Next Page
Loading...
