Introducing The ScopeMeter Test Tool 1 - 3
USING THE HOLSTER AND THE TILT STAND
The ScopeMeter test tool is cradled in a holster that provides
shock protection during rough handling. All keys and
connections are accessible with the holster in place. You will
need to remove the holster only to replace the batteries.
(See Chapter 8 for battery replacement instructions.)
The test tool is also equipped with a multiposition tilt stand,
allowing viewing from different angles. The stand can also
be used to hang the test tool at a convenient viewing
position. Simply push up on the quick release and tilt the
stand. The tilt stand/bracket is fully usable with the holster
in place. Typical positions are shown in Figure 1-1.
Figure 1-1. Multiposition Stand
RELEASE
HERE
To Next Page
Loading...
