Fluke 105B - MAKING CONNECTIONS

Using in Scope Mode 5 - 3
MAKING CONNECTIONS
Scope connections are illustrated in Figure 5-1.
Maximum scope inputs on either BNC are as follows:
•
Maximum input signal voltage: 300V rms direct
•
Maximum input signal voltage: 600V rms when using
10:1 probe
•
Voltage to ground: 600V rms
Input impedance is 10 MΩ/15 pF with the 10:1 probe.
•
Press and to select the Scope mode.
WARNING
To prevent electric shock and personal injury, Mini Test
Hooks and HF Adapters must not be connected to any
voltage higher than 42V peak (30V rms) to earth.
Always pay attention to the markings on the
accessories.
Figure 5-1. Scope Connections