Using Additional Capabilities 6 - 17
USING THE WAVEFORM GENERATOR
Press and then to open the GENERATE menu.
You can now select a waveform output at the red (GENE-
RATOR OUT) and black (COMmon) 4-mm banana jacks.
Figure 6-9. Generator Menu
1. Select GENERATOR OUTPUT and turn the generator
on and off.
2. Choose one of the six waveforms:
Square wave: 1.95kHz, 976Hz, or 488Hz (all at
5V p-p)
Sine wave: 976 Hz (1V p-p)
Slow ramp: Voltage (-2V to +2V, 1 mA maximum)
Current (0 to 3 mA, 2V maximum)
The generator is automatically disabled in the , ,
and mode.
The generator output can also be selected as trigger
source; when turned on, it replaces the EXT (external)
trigger source in the TRIGGER menu.
TESTING COMPONENTS
Figure 6-10. Component Test Setup
From the Special Functions menu, press to use the
ScopeMeter test tool as a predefined measuring tool for
components. This opens the Component Test menu.
1. Select COMPONENT MENU and turn the component
test on and off.
92B
96B
92B 96B
To Next Page
Loading...
