10. Adjust the trigger level: the " " icon moves upward as you change the trigger level. When
the level is more than the waveform value, RUN changes into NOTRIG, and the display
becomes unstable; your test tool is no longer triggered.
11. Adjust the trigger level to about 50% of the waveform amplitude, so that your test tool is
triggered again.
12. Turn your ScopeMeter test tool off.
You are now able to operate basic functions in routine applications. Continue with Chapters 3 and 4 for a more detailed
discussion of the ScopeMeter test tool functions.
To Next Page
Loading...
