True-rms Digital Multimeter
Maintenance
39
Replace the batteries as follows, refer to Figure 11:
1. Turn the rotary switch to OFF and remove the test
leads from the terminals.
2. Remove the six Torx-head screws from the case
bottom and remove the battery door ().
Note
When you lift the battery door, make sure the
rubber gasket stays attached to the battery
compartment barrier.
3. Remove the three batteries and replace all three with
AAA Alkaline batteries ().
4. Make sure the battery compartment gasket () is
properly installed around the outside edge of the
battery compartment barrier.
5. Align the battery compartment barrier with battery
compartment while you replace the battery door.
6. Attach the door with the six Torx-head screws.
Note
Fluke recommends that you remove the
batteries from the Product for long periods of
storage.
To Next Page
Loading...
