Fluke 52120A - Remote Commands

Remote Operations
Remote Commands 3
3-5
Not Used
2
0
= 1 2
8
= 256
2
1
= 2 2
9
= 512
2
2
= 4 2
10
= 1024
2
3
= 8 2
11
= 2048
2
4
= 16 2
12
= 4096
2
5
= 32 2
13
= 8192
2
6
= 64 2
14
= 16384
2
7
= 128 2
15
= 32768
Questionable Data Binary Wieghts
Event Register Enable Register
STAT:QUES:EVEN? STAT:QUES:ENAB <value>
STAT:QUES:ENAB?
"OR"
0
Not Used
Not Used
Not Used
Temperature
Not Used
Not Used
Not Used
Not Used
Over Compliance
Not Used
9
4
Not Used
10
Not Used
Not Used
15
Input Over-range
Not Used
Not Used
Not Used
Operation Status
Status Register Enable Register
STAT:QUES:EVEN? STAT:QUES:ENAB <value>
STAT:QUES:ENAB?
"OR"
0
Not Used
Not Used
Not Used
Not Used
Not Used
Not Used
Not Used
Not Used
Not Used
Not Used
Not Used
Not Used
Not Used
15
Not Used
Not Used
Not Used
Operation Complete
Standard Event
Event Register Enable Register
*ESR? *ESE <value>
*ESE?
"OR"
0
Not Used
Query Error2
Device Error3
Execution Error4
5
Command Error
7
Not Used
Power On
Not Used
Status Byte
Summary Register Enable Register
Serial Poll (SPOLL)
*STB?
*SRE <value>
*SRE?
0
Not Used
Not Used
Questionable Data
3
Message Available
4
5
Standard Event
7
6
Request Service
Operational Data
gpp011.eps
Figure 3-2. SCPI Status Registers
Bits 9 and 10 of the questionable data register do not get set on the condition register.
They are transitory hardware events that clear three milliseconds after they are set. You
can only see them in the STAT:QUES? register.
Remote Commands
This section documents the IEEE-488 remote commands for the Product. Remote
commands duplicate operations that can be done from the front panel in local operation.
A complete alphabetical list of all commands, with protocol instructions, follow the
summary tables. The parameters and responses for each command is shown, plus an
example for each command.