Fluke 7102 - Specifications

7102
User’s Guide
4
Specifications
Table 1. Specifications
Range −5 °C to 125 °C (23 °F to 257 °F)
Accuracy ±0.25 °C
Stability
±0.015 °C at −5 °C (oil, 5010)
±0.03 °C at 121 °C (oil, 5010)
Uniformity ±0.02 °C
Resolution 0.01 °C/F
Operating Temperature 5 °C to 45 °C (41 °F to 113 °F)
Heating Time 25 °C to 100 °C (77 °F to 212 °F): 30 minutes
Cooling Time 25 °C to 0 °C (77 °F to 32 °F): 30 minutes
Well Size
64 x 139 mm deep (2.5 in dia. x 5.5 in)
(access opening is 48 mm [1.9 in] in diameter)
Exterior Dimension 31 cm x 18 cm x 24 cm (12 in H x 7.2 in W x 9.5 in D)
Weight 6.8 kg (15 lb) with fluid
Power 115/230 VAC (±10 %), 50/60 Hz, 300 VA
Fuse Rating T, 4 A, 250 V
Readout Switchable °C or °F
Controller Digital controller with data retention
Thermal Electric Devices (TED) 150 W
Cooling Fan and Thermal Electric Devices (TED)
Environmental Conditions
Ambient Temperature Range 5 °C to 45 °C (41 °F to 113 °F)
Ambient Relative Humidity maximum 80 % for temperature <31 °C, decreasing linearly to 35 % at 45 °C
Altitude <2000 m
Fault Protection Sensor burnout and short protection
Safety
General
Heating
IEC 61010-1: Overvoltage Category II, Pollution Degree 2
IEC 61010-2-010
Electromagnetic Compatibility (EMC)
International.......................IEC 61326-1: Basic Electromagnetic Environment
CISPR 11: Group 1, Class A
Group 1: Equipment has intentionally generated and/or uses conductively-coupled radio
frequency energy that is necessary for the internal function of the equipment itself. Class
A: Equipment is suitable for use in all establishments other than domestic and those
directly connected to a low-voltage power supply network that supplies buildings used for
domestic purposes. There may be potential difficulties in ensuring electromagnetic
compatibility in other environments due to conducted and radiated disturbances. Caution:
This equipment is not intended for use in residential environments and may not provide
adequate protection to radio reception in such environments.
Korea (KCC)....................Class A Equipment (Industrial, Broadcasting,
& Communication Equipment)
Class A: Equipment meets requirements for industrial electromagnetic wave equipment
and the seller or user should take notice of it. This equipment is intended for use in
business environments and not to be used in homes.
USA (FCC) .....................47 CFR 15 subpart B. This product is considered an exempt
device per clause 15.10