Micro-Bath
Environmental Conditions
5
Environmental Conditions
See Safety Information for cautions that deal with environmental conditions. Maintenance and cleaning
recommendations can be found in Maintenance. Vibrations in the calibration environment should be
minimized, see Bath Environment.
Quick Start
W
Caution
Read Bath Use before placing the bath in service. Incorrect handling can damage the
Product and void the warranty.
Unpacking
Unpack the Product carefully and inspect it for any damage that may have occurred during shipment. If
there is shipping damage, notify the carrier immediately.
Verify that these components are present:
• 7102 Micro-Bath
• 7102/7103 Safety Information
• Transport/Pour Access Lid
• Probe Basket
•Stir Bar
• Power Cord
• Report of Calibration
• Calibration Label
• Access Cover, optional
• Well Extender, optional
Bath Environment
Locate the Product in an appropriate environment. Make sure that the location is free of drafts, extreme
temperatures, temperature changes, and contaminates. Place the bath on a heat-proof surface such
as concrete with at least 15 cm (6 in) of clearance around the bath. Beware of the danger of accidental
fluid spills.
To Next Page
Loading...
