725Ex
Users Manual
14
Table 4. Key Functions (cont.)
No. Key Description
A,M
A,M
OY
OZ
Disables Shut Down Mode
Enables Shut Down Mode
M XW Y
Z
Increases or decreases the source level.
Cycles through the 2-, 3-, and 4-wire selections.
Moves through the memory locations of calibrator setups.
In Contrast Adjustment mode; up-darkens contrast, down-lightens contrast.
N Q
Retrieves a previous calibrator setup from a memory location.
O S
Saves the Calibrator setup. Saves Contrast Adjust setup.
P
M
Cycles the Calibrator through MEASURE and SOURCE modes in the lower display.
Q T
Selects the TC (thermocouple) measurement and sourcing function in the lower display.
Repeated pushes cycle through the thermocouple types.
R V
Toggles between voltage, mA sourcing, or mA simulate functions in the lower display.
S R
Selects RTD (resistance temperature detector) measurement and sourcing function in lower
display. Repeated pushes cycle through the RTD types.
T U
Selects the pressure measurement and sourcing function. Repeated pushes cycle through the
different pressure units.
To Next Page
Loading...
