Fluke DTX Series - Page 14

DTX Series CableAnalyzer
Users Manual
6
WXWarning
To avoid possible fire, electric shock, or personal
injury:
• Do not open the case; no user-serviceable parts
are inside.
• Do not modify the tester.
• Use only ac adapters approved by Fluke Networks
for use with the DTX tester to charge the battery
or power the tester.
• When servicing the tester, use only specified
replacement parts.
• Do not use the tester if it is damaged. Inspect the
tester before use.
• If this equipment is used in a manner not specified
by the manufacturer, the protection provided by
the equipment may be impaired.
• Never connect the tester to any telephony inputs,
systems, or equipment, including ISDN. Doing so
is a misapplication of this product, which can
result in damage to the tester and create a
potential shock hazard to the user.
• Always turn on the tester before connecting it to
a cable. Turning the tester on activates the tool’s
input protection circuitry.
• Do not use the tester if it operates abnormally.
Protection may be impaired.
WCaution
To avoid disrupting network operation, to
avoid damaging the tester or cables under test,
to avoid data loss, and to ensure maximum
accuracy of test results:
• Never connect the tester to an active network.
Doing so may disrupt network operation.
• Never attempt to insert any connector other
than an 8-pin modular (RJ45) connector into an
adapter’s jack. Inserting other connectors, such
as RJ11 (telephone) connectors, can
permanently damage the jack.