Safety Information
7
•
Never operate portable transmitting devices,
such as walkie-talkies and cell phones, during a
cable test. Doing so might cause erroneous test
results.
•
To ensure maximum accuracy of copper cable
test results, perform the reference procedure
every 30 days as described under “Setting the
Reference”.
•
The permanent link interface adapters may not
perform properly or may be damaged if they
are handled improperly. See pages 16 and 17
for important handling information.
•
Leave the module bay covers in place when
modules are not installed. See page 10.
•
Turn off the tester before attaching or removing
modules.
•
Never remove the memory card while the
memory card’s LED is on. Doing so can corrupt the
data on the card.
•
Memory cards may be lost, damaged, or
accidentally formatted, resulting in data loss.
Therefore, Fluke Networks recommends saving no
more than one day’s worth of test results on a
memory card.
W
*
Warning: Class 1 and Class 2 Laser
Products
To avoid possible eye damage caused by
hazardous radiation, when using the fiber
modules follow the safety guidelines given in
the DTX-MFM2/GFM2/SFM2 Fiber Module Users
Manual or the DTX Series CableAnalyzer
Technical Reference Handbook.
To Next Page
Loading...
