Certifying Coaxial Cabling
33
To set the reference, do the following:
1
Attach coaxial adapters to the main and remote
testers, screw in the F-connector to BNC adapters; then
make the connections shown in Figure
16.
2
Turn the rotary switch to SPECIAL FUNCTIONS and
turn on the smart remote.
3
Highlight Set Reference; then press H. If both a
fiber module and copper adapter are attached, select
Link Interface Adapter.
4
Press P.
amd140.eps
Figure 16. Coaxial Reference Connections
TEST
LOW BATTERY
TONE
TALK
FAI L
TEST
PAS S
TALK
TALK
MONITOR
ENTER
TEST
SAVE
SPECIAL
FUNCTIONS
SETUP
AUTO
TEST
SINGLE
TEST
EXIT
F1 F2 F3
To Next Page
Loading...
