Flyability Elios 3 - Software Errors

ELIOS 3 User Manual
S01
Drone didn't shut down
correctly
Check for a CRD file on the Avionics SD card and contact Flyability
Support.
S02
Communication protocol
version mismatch
Not the same starnet version on Cockpit and Drone (i.e., starnet
mismatch). Please update both Cockpit and the drone.
S03
Transmission FW version
mismatch
Transmission FW version mismatch between ground and air unit.
S04
Cockpit version not compatible
with the drone
Please make sure that both systems are up to date.
S05
Avionics stopped logging
The avionics stopped logging.
S06
OBC is initializing
The OBC logging system is initializing. Please wait until it does so.
S07
OBC did not initialize properly
The OBC logging system did not initialize properly and thus
timed out. Please wait until it restarts and properly initiates.
S08
OBC logging system failure
OBC logging failure—please restart the drone.
S09
Drone cannot be armed in
current state
The drone cannot be armed in the current state. Please restart it.
Contact Flyability support if a problem persists.
S10
Unable to communicate with the
ethernet switch
Internal communication error.
S11
Switch status doesn't show a
connected port on OBC side
Internal communication error.
S12
Switch status doesn't show a
connected port on LiDAR side
Internal communication error.
S13
Altitude estimation error
Altitude estimation error, drone cannot be armed in current
state—please restart the drone.
ELIOS 3 User Guide
Page 82 of 94