170
• If necessary, clean the brake discs with a suit
-
able brake cleaner approved by the manufac-
turer
• Clean all bearings as required and lubricate
them with suitable lubricant approved by the
manufacturer
• Clean suspension elements as required and
lubricate them with original lubricant approved
by the suspension manufacturer
• Clean all moving parts for which lubrication is
intended (especially quick release fasteners,
quick release axles and the joints) as required
and lubricate them with a suitable lubricant ap
-
proved by the manufacturer
Allow your FLYER specialist retailer to instruct
you.
What to do after riding in rain, snow or wet
conditions:
(in addition to the points under “After each ride”)
FLYER driver
• Clean the chain and lubricate it with a suitable
lubricant approved by the manufacturer
• Clean the brake
• Clean the gear system
• Check the sufcient lubrication of all compo
-
nents
Allow your FLYER specialist retailer to instruct
you.
Monthly – FLYER driver
Check that all screws, nuts, quick release axles
and quick release fasteners are rmly attached
Every year or after every 1000 km, whichever
occurs rst
FLYER specialist retailer
• Lubrication of all moving parts for which lubri
-
cation is intended (excluding brake surfaces)
• Visual inspection of the frame and of
components for cracks and damage
• Mend paint damage
• Replace parts with rust spots
• Treat all bare metal parts (excluding brake sur
-
faces) against corrosion (rust)
• Change defective or damaged parts
• Check the wheels and centre them as required
• Check the tension of the spokes
• Check and clean the chain/sprocket/cogset
• Lubricate the chain with a suitable lubricant
• Check the rim for wear
• Check the brake pads for wear
• Check that all screws, nuts, quick release axles
and quick release fasteners are rmly attached
• Check the brake system and quick release ax
-
les and adjust it or replace parts if necessary
• Check the gear system and adjust or replace
parts of it if necessary
• Check the hubs
• Check the headset
• Check the pedals
Only use cleaning agents and lubricants
that are recommended or approved by
the component manufacturer.
Please note that not all lubricants and
care products are suitable for your
FLYER. By using unsuitable lubricants
or care products, you can damage or im
-
pact the functionality of your FLYER
e-bike.
Ensure that the brake pads, brake discs
and brake surfaces are not exposed to
cleaning or servicing uids or oils, as this
reduces the performance of the brakes.
23.1 Maintenance work and ex-
change of wearing parts
Components to be changed may only be
replaced with identical, original parts.
Wearing parts may only be replaced with
identical, original components.
Using any parts other than the original
ones will immediately cause the manu
-
facturer’s liability for material defects
and/ or the manufacturer’s warranty ser
-
vice to become void. There is also an
increased risk of accidents or falls.
To Next Page
Loading...
Need help?
General
